The CO2 problem in 6 easy steps

We often get requests to provide an easy-to-understand explanation for why increasing CO2 is a significant problem without relying on climate models and we are generally happy to oblige. The explanation has a number of separate steps which tend to sometimes get confused and so we will try to break it down carefully.

Step 1: There is a natural greenhouse effect.

The fact that there is a natural greenhouse effect (that the atmosphere restricts the passage of long wave (LW) radiation from the Earth’s surface to space) is easily deducible from i) the mean temperature of the surface (around 15ÂșC) and ii) knowing that the planet is roughly in radiative equilibrium. This means that there is an upward surface flux of LW around \sigma T^4 (~390 W/m2), while the outward flux at the top of the atmosphere (TOA) is roughly equivalent to the net solar radiation coming in (1-a)S/4 (~240 W/m2). Thus there is a large amount of LW absorbed by the atmosphere (around 150 W/m2) – a number that would be zero in the absence of any greenhouse substances.

Step 2: Trace gases contribute to the natural greenhouse effect.

The fact that different absorbers contribute to the net LW absorption is clear from IR spectra taken from space which show characteristic gaps associated with water vapour, CO2, CH4, O3 etc (Harries et al, 2001; HITRAN). The only question is how much energy is blocked by each. This cannot be calculated by hand (the number of absorption lines and the effects of pressure broadening etc. preclude that), but it can be calculated using line-by-line radiative transfer codes. The earliest calculations (reviewed by Ramanathan and Coakley, 1979) give very similar results to more modern calculations (Clough and Iacono, 1995), and demonstrate that removing the effect of CO2 reduces the net LW absorbed by ~14%, or around 30 W/m2. For some parts of the spectrum, IR can be either absorbed by CO2 or by water vapour, and so simply removing the CO2 gives only a minimum effect. Thus CO2 on its own would cause an even larger absorption. In either case however, the trace gases are a significant part of what gets absorbed.

Step 3: The trace greenhouse gases have increased markedly due to human emissions

CO2 is up more than 30%, CH4 has more than doubled, N2O is up 15%, tropospheric O3 has also increased. New compounds such as halocarbons (CFCs, HFCs) did not exist in the pre-industrial atmosphere. All of these increases contribute to an enhanced greenhouse effect.

Step 4: Radiative forcing is a useful diagnostic and can easily be calculated

Lessons from simple toy models and experience with more sophisticated GCMs suggests that any perturbation to the TOA radiation budget from whatever source is a pretty good predictor of eventual surface temperature change. Thus if the sun were to become stronger by about 2%, the TOA radiation balance would change by 0.02*1366*0.7/4 = 4.8 W/m2 (taking albedo and geometry into account) and this would be the radiative forcing (RF). An increase in greenhouse absorbers or a change in the albedo have analogous impacts on the TOA balance. However, calculation of the radiative forcing is again a job for the line-by-line codes that take into account atmospheric profiles of temperature, water vapour and aerosols. The most up-to-date calculations for the trace gases are by Myhre et al (1998) and those are the ones used in IPCC TAR and AR4.

Page 1 of 3 | Next page